When your PO is accidentally closed and your invoice status shows as fully invoiced and need to do changes or add products in line level you will get an error if the PO is closed and fully invoiced as shown in fig 1.1. We can achieved this by re-opening the close orders. To Re-open a… Read More »
Normally, a Sage ERP X3 window closes on click of End or Ok button. However, if you want to close a window on specific Actions or Click of Custom Buttons, then it can be done with custom development. New Stuff: Disallow shipments when Short quantities in Sage ERP X3 While doing a custom development we… Read More »
While integrating the Sage X3 with third party application I came across a scenario where I needed to close my X3 screen when another application opens up and that also from the same screen. Doing that was little bit technically complicated but after some findings and research, I found a solution which solved my problem.… Read More »